Skip to main content
Release Notes 05/12/2021
Support avatar
Written by Support
Updated over a week ago


  • A checkbox has been added to the portal to allow users to enable or disable 2 Factor Authentication. Previously there was no option to enable or disable this within the portal directly.

  • A filter has been added to the Customers > Orders page, to search for orders that are 3D protected. This applies for both 3D Verify and 3D Secure.

  • The 'card_nonce' parameter has been added to the API order_update call. This is for Square transactions ONLY, and will allow you to pass the card_nonce in the order_update call when updating a customers payment information.

Resolved Issues

  • There was an issue where if customers updated their address information from the membership portal, the information was not being properly sync'd to sticky. This has been fixed.

  • An issue was reported regarding ShipStation where we were combining similar addresses but then also sending an individual post for the latest order posting the product again. This has been fixed.

Did this answer your question?